Hitachi VSP G1000 User Manual page 221

SSB2 CCI command
97CF paircreate
97D4 All commands
97D5 All commands
97D6 All commands
97D7 All commands
97D8 All commands
97D9 All commands
97DA paircreate, map
snapshot
97DD unmap snapshot/
replace snapshot
97DE map snapshot/
unmap snapshot/
replace snapshot
97DF map snapshot
97F1 replace snapshot
97F1 map snapshot/
replace snapshot
97FA unmap snapshot/
replace snapshot
B912 paircreate, pairsplit,
pairresync
B9A7 All commands
FF58 pairsplit, pairresync,
pairresync -restore
FF59 paircreate
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series
You cannot create the HTI pair because an HTI group is already
using the CG number you specified.
The command ended abnormally because you are in the process of
turning off the power.
You cannot run the command because even though the specified
serial number matches the virtual storage machine, the physical
storage system's serial number that corresponds with the virtual
storage machine's serial number does not match when the virtual
storage machine's serial number is specified for P-VOL and S-VOL.
You cannot run the command because the model, serial number, or
virtual LDEV ID of the volume specified as P-VOL is being changed.
You cannot run the command because the model, serial number, or
virtual LDEV ID of the volume specified as S-VOL is being changed.
The pair operation was rejected because one of the following
conditions holds for the volume that is specified as the HTI P-VOL:
• The volume is used as a global-active device pair volume and
does not accept pair operations.
• The volume is specified reservation attribute of a global-active
device.
The pair operation was rejected because one of the following
conditions holds for the volume that is specified as the HTI S-VOL:
• The volume is used as a global-active device pair volume.
• The volume is specified reservation attribute of a global-active
device.
The command ended abnormally because the T10 PI settings for
the P-VOL and S-VOL did not match.
The command ended abnormally because you specified a pair to
which an S-VOL is not assigned.
The operation failed because different DKCMAIN microcode
versions are mixed. Confirm DKCMAIN microcode version.
The command ended abnormally because you specified an S-VOL
that is assigned to a pair.
The command ended abnormally because the pair cannot be
identified from snapshot data and the P-VOL that you specified.
The command ended abnormally because you specified a pair to
which an S-VOL is assigned.
The command ended abnormally because you specified an S-VOL
that is not assigned to a pair.
The HTI pair task failed because you specified the incorrect S-VOL.
You cannot retrieve the consistency group information because HTI
is not installed.
The command ended abnormally because the specified pair is a
cascaded pair.
The command ended abnormally because the specified P-VOL is
used by a cascaded pair.
CCI command reference for Thin Image
Cause of error
221