Hitachi VSP G1000 User Manual page 218

975C
975D
975E
976A
976C
976E
976F
9772
9774
9777
977A
977B
977C
977D
977E
9783
218
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series
SSB2 CCI command
paircreate, pairsplit,
pairresync,
pairresync -restore
All commands
All commands
paircreate
pairsplit
pairsplit
pairsplit
paircreate
paircreate
paircreate
paircreate, pairsplit
paircreate, pairsplit
pairresync -restore
pairresync -restore
pairsplit
pairresync -restore
CCI command reference for Thin Image
The command ended abnormally because you specified a DP-VOL
for which the Data Direct Mapping attribute is enabled as the HTI
S-VOL.
The command ended abnormally because you specified a Volume
Migration V2 source volume as the HTI S-VOL.
For more information about using Volume Migration V2, contact
customer support.
The command ended abnormally because you specified a Volume
Migration V2 target volume as the HTI S-VOL.
For more information about using Volume Migration V2, contact
customer support.
An unavailable parameter (unsupported parameter) is specified in
the command.
You cannot store the snapshot data because you have run the
command when the pair is suspended and blocked ("PSUE"
status).
The snapshot data cannot be stored because the HTI P-VOL and a
TC S-VOL share the volume, and the status of the TC pair is
"COPY".
Snapshot data cannot be stored because the HTI P-VOL and a UR
S-VOL share the volume, and the status of the UR pair is "COPY".
The HTI pair cannot be created because you specified a UR delta
resync pair volume as the HTI S-VOL.
The HTI pair cannot be created because the HTI P-VOL and an SI
P-VOL share the volume, and the MU number you specified for the
HTI pair is already used by the SI pair.
The HTI pair cannot be created because the HTI P-VOL and an SI
S-VOL share the volume, and you specified MU number zero (0) for
the HTI P-VOL.
The command ended abnormally because the HTI P-VOL and an SI
P-VOL share the volume, and the SI pair was in the process of
resynchronization.
The command ended abnormally because the HTI P-VOL and an SI
S-VOL share the volume, and the SI pair status is not "PSUS".
You cannot restore the HTI pair because the HTI P-VOL and an SI
P-VOL share the volume, and the SI pair is not split ("PSUS"
status) or is suspended and blocked ("PSUE" status).
The HTI pair cannot be restored because the HTI P-VOL and an SI
S-VOL share the volume, and the SI pair is not split ("PSUS"
status).
Snapshot data cannot be stored because the pool or the pool-VOL
is blocked.
You cannot restore the HTI pair because of one of the following
reasons:
• You are storing snapshot data for the HTI pair that you want to
restore using the consistency group to which the pair is
assigned.
• You are using the P-VOL of the HTI pair you want to restore as
the P-VOL for another HTI pair, and you are storing the
Cause of error