Water Filter Status Light; Water Filtration System - Kenmore 106.5942 series Use & Care Manual

Table of Contents

Advertisement

Available languages

Available languages

The Dispenser Light (on some models)
The dispenser
area
has a light. It can be turned on manually
by
pressing
the ON
button
(touchpad
or rocker
switch).
On some models:
Whenever
you use the dispenser,
the lever will
automatically
turn the light on.
LIGHT
NOTE:
See "Changing
the Light Bulbs"
for information
on
changing
the dispenser
light
bulb.
The Dispenser
Lock
(on some
models)
The dispenser
can be turned
off for easy cleaning
or to avoid
unintentional
dispensing
by small
children
and pets.
NOTE:
The lock feature
does not shut off power
to the
refrigerator,
to the ice maker,
or to the dispenser
light. It simply
deactivates
the dispenser
levers.
To turn off the dispenser,
press the LOCI<
button.
The
indicator
will appear
above
the LOCI< button
and the ice
and water
dispensers
will not work.
To unlock the dispenser,
press the UNLOCK
button
until the
indicator
appears.
Then continue
to dispense
ice or water
as
usual.
DISPENSER
LOCK
UNLOCK
The water
filter
status light will help you know
when to change
your water
filter.
When
the status light changes
from green
to yellow,
this tells
you that it is almost
time
to change
the water
filter.
It is recommended
that you replace
the filter
when the status
light
changes
to red OR when
water
flow
to your
water
dispenser
or ice maker
decreases
noticeably.
The filter
should
be replaced
at least every
6 months
depending
on your
water
quality
and usage.
To change
the filter,
see
"Water
Filtration
System."
INDICATOR:
STATUS:
GOOD
(green)
New
filter
installed
ORDER
(yellow)
Order
filter
REPLACE (red) OR
Replace
water
filter
when water
flow
decreases
After
changing
the water
filter,
reset the status light by pressing
and holding
the RESET button
for 2 seconds.
The status light will
change
from
Replace
(red) to Good
(green)
when the system
is
reset.
WATER
FILTER
GOOD •
ORDER •
R_SET
RH_AC •
Do not use with water that is microbiologically
unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Changing the Water
Filter
The water
filter
is located
in the base grille
below
the freezer
compartment
door.
It is not necessary
to remove
the base grille
to remove
the filter.
1.
Remove
the filter
by pressing
the eject button
and pulling
straight
out on the filter
cap.
NOTES:
Avoid
twisting
the cap when
removing
the filter
because
this could
cause the cap to come
off.
If this occurs,
replace
the cap and
pull the filter
straight
out.
There will be water
in the filter.
Some spilling
may occur.
A
.......................
2.
A. Eject button
B. Filter cap
Remove
the cap
by turning
it counterclockwise
until it stops.
IMPORTANT:
Do not discard
the cap.
It is part
of your
refrigerator.
Keep
the cap to use with
the replacement
filter.
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

106.5943 series106.5110 series

Table of Contents