Water Filter Status Light; Water Filtration System - Kenmore 106.5029 series Use & Care Manual

The Dispenser Lock (on some models)
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the refrigerator,
to the ice maker, or to the dispenser light. It simply deactivates the
dispenser controls and levers. To turn off the ice maker, see "Ice
Maker and Storage Bin."
Press and hold LOCK for 3 seconds to lock the dispenser.
Press and hold LOCK a second time to unlock the dispenser.
The display screen indicates when the dispenser is locked.
LOCKED

Water Filter Status Light

The water filter status light will help you know when to change your
water filter. When the water filter status display changes from
"GOOD" to "ORDER," this tells you that it is almost time to change
the water filter cartridge. Replace the water filter cartridge when
the water filter status display changes to "REPLACE." If water flow
to your water dispenser or ice maker decreases noticeably, change
the filter sooner. The filter should be replaced at least every
6 months depending on your water quality and usage. To change
the filter, see "Water Filtration System."
INDICATOR:
NEW or GOOD (green)
ORDER (yellow)
REPLACE (red) OR
when water flow decreases
After changing the water filter, reset the status light by pressing
and holding the FILTER button for 3 seconds. The status light will
change from Replace (red) to New/Good (green) when the system
is reset.
Style 1
UNLOCKED
STATUS:
New filter installed
Order filter
Replace water filter
Style 2

Water Filtration System

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Changing the Water Filter
The water filter is located in the base grille below the freezer
compartment door. It is not necessary to remove the base grille to
remove the filter.
1. Remove the filter by pressing the eject button and pulling
straight out on the filter cap.
NOTES:
Avoid twisting the cap when removing the filter because
this could cause the cap to come off. If this occurs, replace
the cap and pull the filter straight out.
There will be water in the filter. Some spilling may occur.
A
A. Eject button
B. Filter cap
2. Remove the cap by turning it counterclockwise until it stops.
IMPORTANT: Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
3. Take the new cartridge out of its packaging and remove the
covers from O-rings.
A
B
A. Cover
B. O-ring
B
13