Mitsubishi MELSEC-F FX2N-1RM-E-SET User Manual page 57

FX -1RM-E-SET Programmable Cam Switch
2N
• Please separate angle advance quantity from previous ON/OFF 1 degree (1 degree mode)
or 0.5 degrees (0.5 degrees mode) or more. (Refer to the figure 1 below)
Figure 1
Y0
Y0
0 degree
• Selection of use/do not use, input of the rotational speed, and angle advance quantity can be
set by the data operation panel and the PLC main unit.
Use specification of individual automatic angle advance function
From the data setting panel : Set by FNC 05 → Refer to 8.3.6
From the PLC
Setting of rotational speed and angle advance quantity
From the data setting panel : Set by FNC 90 → Refer to 8.3.6
From the PLC
Please input the rotational speed and angle advance quantity after specifying the use of the
function.
(When the use of the function is not specified, it becomes an error.)
ON angle OFF angle
advance advance
quantity quantity
1 degree or
1 degree or
0.5 degrees
0.5 degrees
or more
or more
: Bit5 of BFM #0 is turned ON → Refer to 7.2
Input by one time value
: Input to BFM #6376 to #6459 → Refer to the next page
Input value equals advance angle (1 degree mode)
Input value equals twice the advance angle (0.5 degrees mode)
ON angle OFF angle
advance advance
quantity quantity
1 degree or
0.5 degrees
or more
Basic Setting 6
Individual automatic angle
advance function unused.
Individual automatic angle
advance function used.
359 degrees
6-7