Confirming And Deleting The Setting - Mitsubishi MELSEC-F FX2N-1RM-E-SET User Manual

FX -1RM-E-SET Programmable Cam Switch
2N
8.3.17

Confirming and deleting the setting

When FNC70 to FNC75 are already set, the existing setting can be displayed or deleted using a
usual read/deletion operation.
Displaying the existing setting [FNC70 to FNC75]
< Key operation > (Example of [FNC70])
BANK 0
OUT 0
+
+
Deleting the existing setting [FNC70 to FNC75]
< Key operation >
By performing the procedure described in "8.2.5 Deletion", the output setting related to each of
FNC70 to FNC75 is deleted.
GO
Specify an output No. from
GO
which the current value is to be
output.
Program Operating Procedures 8
[Power ON] [PRG mode]
< Display >
BANK OUT STEP
0 0 0
*1 The FNC No. to set the BCD current value
already registered is displayed.
BANK OUT STEP
0 0 0
*2 Existing strobe width set value
BANK OUT STEP
0 0 1
DEG ON LED OFF LED
F70 Exting-
Lit
*1 uished
DEG ON LED OFF LED
20 Exting-
Lit
*2 uished
DEG ON LED OFF LED
Exting-
Blank Lit
uished
8-29