Acl Metering Configuration; Acl Re-Mark Configuration; Acl Re-Mark In-Profile Configuration - NEC N8406-023 Command Reference Manual

ACL Metering configuration

The following table describes the ACL Metering Configuration commands.
Table 160 ACL Metering Configuration commands
Command
access-control list <ACL
number> meter committed-rate
<64-1000000>
access-control list <ACL
number> meter maximum-burst-
size <32-4096>
[no] access-control list
<ACL number> meter enable
access-control list <ACL
number> meter action
{drop|pass}
default access-control list
<ACL number> meter
show access-control list
<ACL number> meter

ACL Re-mark configuration

You can choose to re-mark IP header data for the selected ACL. You can configure different re-mark values, based
on whether packets fall within the ACL Metering profile, or out of the ACL Metering profile.
The following table describes the ACL Re-mark Configuration commands.
Table 161 ACL Re-mark Configuration commands
Command
[no] access-control list <ACL
number> re-mark
default access-control list <ACL
number> re-mark
show access-control list <ACL
number> re-mark

ACL Re-mark In-Profile configuration

The following table describes the ACL Re-mark In-Profile Configuration commands.
Table 162 ACL Re-mark In-Profile Configuration commands
Command
[no] access-control list <ACL
number> re-mark in-profile
dscp <0-63>
default access-control list
<ACL number> re-mark
show access-control list <ACL
number> re-mark
Description
Configures the committed rate, in Kilobits per second. The committed rate
must be a multiple of 64. The default is 64.
Command mode: Global configuration
Configures the maximum burst size, in Kilobits. Enter one of the following
mbsize
values for : 32, 64, 128, 256, 512, 1024, 2048, 4096
The default is 32.
Command mode: Global configuration
Enables or disables Metering on the ACL. The default is disabled.
Command mode: Global configuration
Configures the ACL Meter to either drop or pass out-of-profile traffic.
Command mode: Global configuration
Reset ACL Metering parameters to their default values.
Command mode: Global configuration
Displays the current ACL metering parameters.
Command mode: All
Description
Assign an ACL for DSCP Re-marking.
Command mode: Global configuration
Reset ACL Re-mark parameters to their default values.
Command mode: Global configuration
Displays the current ACL re-mark parameters.
Command mode: All
Description
Sets the DiffServ Code Point (DSCP) of In-Profile packets to the selected
value.
Command mode: Global configuration
Resets the update DSCP parameters to their default values.
Command mode: Global configuration
Displays the current ACL re-mark parameters.
Command mode: All
N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (ISCLI) 138