Stamina 55-1550 Owner's Manual page 12

ASSEMBLY INSTRUCTIONS
STEP 13
Insert the upper end of the HANDRAIL(4) into the REAR FRAME(3) and secure with BUTTON HEAD
BOLT(M8x1.25x40mm)(47). Do no tighten the bolt. Attach the lower end of the HANDRAIL(4)
to the REAR FRAME(3) with BUTTON HEAD BOLT(M8x1.25x20mm)(48), BUTTON HEAD
BOLT(M8x1.25x65mm)(43), and ARC WASHERS(M8)(54). Tighten the BUTTON HEAD BOLT
(M8x1.25x40mm)(47). Repeat on other side.
STEP 14
Pull the ADJUSTMENT KNOB(28) and insert the LEG ADJUSTMENT FRAME(10) into the SWING
BAR(9). Bolt the ROUND HEAD BOLT(M6x1x20mm)(51) into the SWING BAR(9).
NOTE: The pin on the ADJUSTMENT KNOB(28) must be inserted into one of the adjustment holes in
the LEG ADJUSTMENT FRAME(10). The ADJUSTMENT KNOB(28) should be screwed in tight
to make the LEG ADJUSTMENT FRAME(10) fit securely in the SWING BAR(9).
STEP 15
Insert the FOAM PAD TUBES(39) through the LEG ADJUSTMENT FRAME(10) and the LEVER(11).
Slide the FOAM PADS(36) onto both sides of the FOAM PAD TUBES(39). Press the ROUND
PLUGS(20) into the FOAM PAD TUBES(39).
12