Stamina 55-1550 Owner's Manual page 11

ASSEMBLY INSTRUCTIONS
STEP 11
Attach the SEAT BELT(60) to the BACK FRAME(5) with FLAT HEAD BOLT(M6x1x20mm)(61) and
WASHER(M10)(52).
CAUTION: Always use the SEAT BELT(60). Make sure the SEAT BELT(60) is securely fastened before
inverting.
STEP 12
Refer to the Back View of the illustration below. Align the hook and loop pad on the HINGE WEAR
COVER(15) and the BACK CUSHION(14), then press them to attach together. Attach the BACK
CUSHION(14) to the BACK FRAME(5) with BUTTON HEAD BOLTS(M6x1x20mm)(51) and WASHERS
(M6)(55).
NOTE: Pull the upper part of the BACK CUSHION(14) back and invert the system so that the BACK
CUSHION(14) and SEAT(13) are in the same plane. Check that the HINGE WEAR COVER(15)
is not too tight or too loose when the unit is in its inverted position. If necessary, adjust the
position of the HINGE WEAR COVER(15) on the BACK CUSHION(14) and the SEAT(13).
Back View
hook and
loop pad
11