About This Document; Installer Reference Guide At A Glance; About The Box; Installation - Daikin EWAQ006BAVP Installer's Reference Manual

2.2 Installer reference guide at a
glance
Chapter
General safety Safety instructions that you must read
precautions before installing
About the documentation What documentation exists for the
installer

About the box

How to unpack the units and remove
their accessories
About the units and ▪ How to identify the units
options
▪ Possible combinations of units and
options
Application guidelines Various installation setups of the system
Preparation What to do and know before going
on‑site

Installation

What to do and know to install the
system
Configuration What to do and know to configure the
system after it is installed
Commissioning What to do and know to commission the
system after it is configured
Hand‑over to the user What to give and explain to the user
Maintenance and service How to maintain and service the units
Troubleshooting What to do in case of problems
Disposal How to dispose of the system
Technical data Specifications of the system
Glossary Definition of terms
Field settings table Table to be filled in by the installer, and
kept for future reference
Note: There is also an installer settings
table in the user reference guide. This
table has to be filled in by the installer
and handed over to the user.
3 About the box
3.1

Overview: About the box

This chapter describes what you have to do after the boxes with the
outdoor unit, control box, option box, and/or backup heater are
delivered on-site.
It contains information about:
▪ Unpacking and handling the units
▪ Removing the accessories from the units
Keep the following in mind:
▪ At delivery, the unit must be checked for damage. Any damage
must be reported immediately to the carrier's claims agent.
▪ Bring the packed unit as close as possible to its final installation
position to prevent damage during transport.
EWAQ+EWYQ006+008BAVP + EK(2)CB07CAV3 +
EKMBUHCA3V3+9W1
Packaged air-cooled water chillers and packaged air to water heat
pumps
4P492901-1 – 2017.06
Description
3.2

Outdoor unit

3.2.1

To unpack the outdoor unit

1
4
4×
5
3.2.2

To handle the outdoor unit

Carry the unit slowly as shown:
CAUTION
To avoid injury, do NOT touch the air inlet or aluminium
fins of the unit.
3.2.3 To remove the accessories from the
outdoor unit
1 Open the outdoor unit. See
page 28.
2 Remove the accessories.
3 About the box
"7.2.2 To open the outdoor unit" on
Installer reference guide
7