Table of Contents
Advertisement
Installing MX-ONE
Figure 47
Note: The board cover must be installed to fulfill the EMC requirement.
1
2
3
4.9
Installing the Fan Unit
This section describes the installation of fan unit and upper air plate in the
cabinet.
Note: If only one subrack is to be installed the fan unit must be strapped for
64
Installing the Board Cover
Fasten the finger plate (B) using four screws (D), Page 64 .
Fasten the board cover (A) above the finger plate using four screws (D) on
the top part, and the two screws (C) on the bottom part, Page 64 .
Install board cover on the other subrack in the same way.
being fed from only one DC/DC converter.
6/1531-ASP 113 01 Uen J2 2008-07-17
Hide quick links:
Advertisement
Table of Contents
