Table of Contents
Advertisement
Installing MX-ONE
To mount the batteries in the battery shelf, perform the following steps:
1. Mount the spacers (K) between the battery blocks (A), Page 45 .
2. Place the safety strap through the slots in the battery shelf, Page 47 .
3. Place the batteries on the shelf. Page 45 . Make sure the front side of the
4. Pull the batteries towards the shelf front edge.
5. Connect the batteries to each other by applying the connector bridge (H),
6. For measuring 12, 24, and 36 V DC insert three contact washers with flat
7. Tighten the six screws.
8. Apply the metal tube spacer (D), plain washer (F), spring washer (G),
9. Apply the metal tube spacer (D), plain washer (F), spring washer (G), and
10. Position insulating pole covers (Y) on each of the four batteries, and press
11. Place the strapping belt (L) around the batteries and tighten the strap,
12. Fasten three warning labels, parallel connection of batteries (SVB 131 70),
46
batteries with the contact poles and the labels is facing the cabinet front.
plain washer (F), spring washer (G), by using the pole screws (C) from the
batteries, Page 45 .
lug terminals (E) on top of each connector bridge, Page 45 .
and 25-mm screw (B) on the plus pole of the rightmost battery block (do
not tighten), Page 45 .
25-mm screw (B) on the minus pole of the leftmost battery block (do not
tighten), Page 45 .
them down, Page 45.
Page 47 .
one on the right-hand side battery, and two at the bottom of the cabinet,
Page 47 and Page 80
6/1531-ASP 113 01 Uen J2 2008-07-17
Hide quick links:
Advertisement
Table of Contents
