Aastra MX-ONE Installation Instructions Manual page 58

Installing MX-ONE
2. Mount four captive nuts in the cabinet to secure the AC/DC unit, Page 52 .
3. Use the screws (C) supplied with the mounting set to fasten the shelves
4.6.4 Installing the AC/DC Unit 230 V (only)
Figure 38
1. If not already done, mount four captive nuts (A) ( Section 4.4 on page 41 )
2. Slide the AC/DC unit between the shelves until it reaches a fixed position,
3. Use the four screws (C) supplied with the mounting kit to fasten the AC/DC
52
It will be difficult to mount these if the shelves have been installed.
(B) to the captive nuts in the cabinet, Page 51.
Note: The four shelves are not identical. The bottom right and top left
shelves are identical, and the top right and bottom left shelves are identical,
Page 51 .
Installing AC/DC Unit 230 V
according to the number positions shown, Page 52 .
Page 52 . Some use of force may be required to firmly fix the unit between
the shelves. In this position it is possible to pull the unit forwards to allow
easier cable connection work.
unit to the captive nuts in the cabinet. Do not tighten the screws, as they
need to be opened again when connecting cables to the AC/DC unit.
6/1531-ASP 113 01 Uen J2 2008-07-17