Geist Watchdog 100 Instruction Manual page 21

To access the unit for the first time, you will need to temporarily change your computer's
network settings to match the 192.168.123. xxx subnet. To set up the unit, connect it to
your computer's Ethernet port, then follow the appropriate instructions for your
computer's operating system.
Windows
· Windows 2000 / XP / Server 2003:
Click the Start button, choose Settings, then Network Connections.
· Windows 7 / Server 2008:
Click the Start button, then choose Control Panel >> Adjust Your Computer's Settings
>> View Network Status and Tasks >> Change Adapter Settings.
(Alternatively, on some Windows 7 machines, this may be Start, then Settings >> Control
Panel >> Network and Sharing Center >> Change Adapter Settings.)
· Windows 8 / Server 2012:
Move the mouse cursor to the bottom or top right corner of the screen, click the Settings
icon, then select Control Panel. Change the view type from Category to Large or Small
Icons if necessary, then select Network and Sharing Center, then Change Adapter
Settings.
· Windows 10:
Click the Start button, then choose Network & Internet, then click Change adapter
options.
Locate the entry under LAN or High-Speed Internet or Local Area Connection which
corresponds to the network card (NIC).
Double-click on the network adapter's entry in the Network Connections list to open its
status dialog box, then click the Properties button to open the Local Properties window.
GM1118 Watchdog 100 Instruction Manual
NOTE
Most computers will have a single Ethernet NIC installed, but a
WiFi or 3G adapter will also show as a NIC in this list, so be
sure to choose the correct entry.
Chapter 2 - Installation 21
© 2017 Geist