Mad Bfd Enable - HPE FlexFabric 12900E Command Reference Manual

Category
Management
ports for ARP MAD
ARP MAD VLAN
ARP MAD and feature
configuration
When you use the mad arp enable command, the system prompts you to enter a domain ID. If you
do not want to change the current domain ID, press enter at the prompt.
An IRF fabric has only one IRF domain ID. You can change the IRF domain ID by using the following
commands: irf domain, mad enable, or mad arp enable. The IRF domain IDs configured by using
these commands overwrite each other.
Examples
# Enable ARP MAD on VLAN-interface 3.
<Sysname> system-view
[Sysname] interface vlan-interface 3
[Sysname-Vlan-interface3] mad arp enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]: 1
The assigned
Related commands
irf domain

mad bfd enable

Use mad bfd enable to enable BFD MAD.
Use undo mad bfd enable to disable BFD MAD.
Syntax
mad bfd enable
undo mad bfd enable
Default
BFD MAD is disabled.
Views
Layer 3 interface view
Management Ethernet interface view
Predefined user roles
network-admin
Restrictions and guidelines
•
Connect a management Ethernet port on each member device to the
common Ethernet ports on the intermediate device. To avoid ARP MAD
failure caused by an active/standby MPU switchover, connect a
Ethernet
management Ethernet port on each MPU to the intermediate device.
•
Make sure the management Ethernet ports for ARP MAD have the same
interface number.
On the intermediate device, create a VLAN for ARP MAD, and assign the
ports used for ARP MAD to the VLAN. On the IRF fabric, you do not need to
assign the management Ethernet ports to the VLAN.
•
Enable the IRF fabric to change its bridge MAC address as soon as the
address owner leaves.
•
If the intermediate device is also an IRF fabric, assign the two IRF fabrics
different domain IDs for correct split detection.
domain ID is: 1
22