Irf Member Renumber - HPE FlexFabric 12900E Command Reference Manual

Predefined user roles
network-admin
Parameters
member-id: Specifies an IRF member ID. The value range for IRF member IDs is 1 to 8. For an HPE
FlexFabric 12916E switch, the member ID must be 1 or 5. For an HPE FlexFabric 12908E switch, the
member ID must be 1 or 3. For an HPE FlexFabric 12904E switch, the member ID must be 1 or 2.
priority: Sets priority in the range of 1 to 32. The greater the priority value, the higher the priority. A
member with higher priority is more likely to be the master.
Usage guidelines
This command is supported only in IRF mode. To assign an IRF priority to a device in standalone
mode, use the irf priority command.
The new priority setting takes effect at the next master election, but it does not trigger a master
election.
Examples
# Set the priority of IRF member 2 to 32.
<Sysname> system-view
[Sysname] irf member 2 priority 32
Related commands
irf priority

irf member renumber

Use irf member renumber to change the member ID of an IRF member device.
Use undo irf member renumber to restore the previous IRF member ID of the device.
Syntax
irf member member-id renumber new-member-id
undo irf member member-id renumber
Default
The device uses the member ID that is set in standalone mode.
Views
System view
Predefined user roles
network-admin
Parameters
member-id: Specifies the ID of an IRF member. The value range for IRF member IDs is 1 to 8. For an
HPE FlexFabric 12916E switch, the member ID must be 1 or 5. For an HPE FlexFabric 12908E
switch, the member ID must be 1 or 3. For an HPE FlexFabric 12904E switch, the member ID must
be 1 or 2.
new-member-id: Assigns a new ID to the IRF member. The value range for IRF member IDs is 1 to 8.
For an HPE FlexFabric 12916E switch, the member ID must be 1 or 5. For an HPE FlexFabric
12908E switch, the member ID must be 1 or 3. For an HPE FlexFabric 12904E switch, the member
ID must be 1 or 2.
17