HPE FlexFabric 12900E Command Reference Manual page 10

Multi-active recovery state: No
Excluded ports(user-configured):
Vlan-interface999
Excluded ports(system-configured):
HundredGigE1/3/0/25
HundredGigE1/3/0/26
HundredGigE2/3/0/27
HundredGigE2/3/0/28
MAD ARP disabled.
MAD ND disabled.
MAD LACP enabled interface: Bridge-Aggregation 1
MAD status
Member ID Port
1 HundredGigE1/3/0/1
2 HundredGigE2/3/0/1
MAD BFD enabled interface: VLAN-interface 3
MAD status
Member ID MAD IP address
1 192.168.1.1/24
2 192.168.1.2/24
Table 5 Command output
Field
MAD ARP disabled.
MAD ND disabled.
MAD LACP enabled.
MAD BFD enabled.
Multi-active recovery state
Excluded
ports(user-configured)
Excluded
ports(system-configured)
: Normal
MAD status
Normal
Normal
: Normal
Neighbor
2
1
Description
Status of ARP MAD.
This field displays MAD ARP enabled if ARP MAD is enabled.
ND MAD is not supported in the current software version.
Status of ND MAD.
This field displays MAD ND enabled if ND MAD is enabled.
Status of LACP MAD.
This field displays MAD LACP disabled if LACP MAD is disabled.
Status of BFD MAD.
This field displays MAD BFD disabled if BFD MAD is disabled.
Whether the IRF fabric is in Recovery state:
•
Yes—The IRF fabric is in Recovery state. When MAD detects that an IRF
fabric has split into multiple IRF fabrics, it allows one fabric to forward
traffic. All the other IRF fabrics are set to the Recovery state. In Recovery
state, MAD shuts down all ports and interfaces in the fabric except for the
following ports and interfaces:
Console ports.
IRF physical interfaces.
Ports and interfaces configured to not shut down by using the mad
exclude interface command.
•
No—The IRF fabric is not in Recovery state. It is active and can forward
traffic.
Ports and interfaces manually configured to not shut down when the IRF fabric
transits to the Recovery state.
Ports and interfaces by default set to not shut down when the IRF fabric
transits to the Recovery state. These ports and interfaces are not user
configurable.
7
MAD status
Normal
Normal