Easy-Irf - HPE FlexFabric 12900E Command Reference Manual

Field
MAD status
Member ID
Port
Neighbor

easy-irf

Use easy-irf to bulk-configure basic IRF settings for an IRF member device.
Syntax
easy-irf [ member member-id [ renumber new-member-id ] domain domain-id [ priority priority ]
[ irf-port1 interface-list1 ] [ irf-port2 interface-list2 ] ]
Views
System view
Predefined user roles
network-admin
Parameters
member member-id: Specifies the member ID of a member device. The value range for the member
ID is 1 to 8. For an HPE FlexFabric 12916E switch, the member ID must be 1 or 5. For an HPE
FlexFabric 12908E switch, the member ID must be 1 or 3. For an HPE FlexFabric 12904E switch, the
member ID must be 1 or 2.
renumber new-member-id: Specifies a new member ID for the device. The value range for the
member ID is 1 to 8. For an HPE FlexFabric 12916E switch, the member ID must be 1 or 5. For an
HPE FlexFabric 12908E switch, the member ID must be 1 or 3. For an HPE FlexFabric 12904E
switch, the member ID must be 1 or 2. The member device automatically reboots for the new
member ID to take effect. If you do not specify this option, the command does not change the
member ID.
domain domain-id: Specifies an IRF domain ID in the range of 0 to 4294967295. Assign the same
domain ID to all devices you are adding to the same IRF fabric.
priority priority: Specifies an IRF priority in the range of 1 to 32. The greater the priority value, the
higher the priority. A member with higher priority is more likely to be the master.
irf-port1 interface-list1: Specifies a space-separated list of up to eight interface items. Each interface
item specifies one interface in the interface-type interface-number form. The interfaces are bound to
IRF-port 1.
irf-port2 interface-list2: Specifies a space-separated list of up to eight interface items. Each interface
item specifies one interface in the interface-type interface-number form. The interfaces are bound to
IRF-port 2. A physical interface can be bound only to one IRF port.
Usage guidelines
This command is supported only in IRF mode.
Description
MAD operating status:
•
Normal—The MAD mechanism is operating correctly.
•
Faulty—The MAD mechanism is not operating correctly. Check the
interface or port for connectivity or configuration problems. For example,
verify that all member devices have member ports used for LACP MAD.
•
N/A—MAD link status cannot be detected. This field always displays N/A
if BFD MAD is enabled on a management Ethernet port.
IRF member ID of the local device.
Member ports of the aggregate interface used for LACP MAD.
IRF member ID of the neighbor member device.
8