Advertisement
Installation Guide
Mounting the Housing
IMPORTANT: The OG1600 Outdoor Gateway is not field-serviceable.
The following sections describe how to mount the OG1600.
Strand Mounting
Before you strand mount the housing, follow the instructions below to attach the strand mount brackets to the base.
1. Attach each strand mount assembly to the housing base, using the 1/4" x 0.625" length bolts that are already
installed in the top of the OG1600 chassis.
The following figure shows the strand mount brackets attached to the OG1600 housing.
Figure 1:
Location of strand mount brackets attached to the OG1600 housing
2. Torque each bolt to between 4 and 6 ft-lbs (between 5.4 and 8.1 N•m)
3. Loosely attach the strand clamps to the strand mount assemblies using the 1/4" x 1.25" length bolts included with
the strand mount assembly, as shown in the following figure.
Figure 2:
Attaching strand clamps to strand mount brackets
Release 16 STANDARD 1.0 August 2016
© 2016 ARRIS Enterprises LLC. All Rights Reserved.
Touchstone® OG1600 Outdoor Gateway
2
Advertisement
