Jp8 (Digital Input Pull-High/Low) - ICP DAS USA PCI-82x Series User Manual

PCI-82x Series Cards
Multifunction Boards
 Jumper Selectable Mode:
DIO-S1 (Port A, PA) and DIO-S2 (Port B, PB) are used to configure the I/O ports as either Digital Input
(connect pins 1 and 2) or Digital Output (connect pins 2 and 3), when the jumper for DIO-S0 is set to
Jumper Selectable Mode. The default configuration is Digital Input.
Jumper
DIO-S1 (Port A)
DIO-S2 (Port B)

2.2.5 JP8 (Digital Input Pull-high/low)

Jumper JP8 is used to set the Digital Input to either Pull-high or Pull-low, which allows the status of
the Digital Input to be predefined instead of remaining floating if the Digital Input channels are
disconnected or interrupted. Connecting pins 1 and 2 will set the Digital Input to Pull-high. To set
the Digital Input to Pull-low, pins 2 and 3 should be shorted. The default connected is Pull-low.
Jumper
JP8
DIO-S0 is Jumper Selectable Mode
DI
(Default)
2 3
1
Pull-low
(Default)
GND
3
2
1
5 V
User Manual, Ver. 1.5, Jan. 2017, PMH-024-15, Page: 13
DO
2 3
1
Pull-high
GND
3
2
1
5 V