Table of Contents
Advertisement
Setting Up the Polycom Instructor RP
Remove the rear access panel from the cabinet.
3
For more information, refer to the "Removing the
Rear Access Panel" section of the Rear Projection
SMART Board 3000i Installation Guide.
Note
The Rear Projection SMART Board 3000i
Installation Guide is produced by SMART
Technologies Inc. Although the
information contained in this document
was accurate at the time of publication,
some procedures or illustrations may
have changed slightly since its inclusion
in the Polycom Instructor RP
documentation set.
4
Install the video conferencing shelf if you want to place the camera on it.
•
If you do not need this shelf for your camera
or for any other device, skip this step.
•
To install the shelf, follow the instructions in
the "Installing the Optional
Videoconferencing Shelf" section of the Rear
Projection SMART Board 3000i Installation
Guide.
•
Typically, you attach the video conferencing
shelf to the right side of the Polycom
Instructor RP system when facing it from the
front. However, you can attach it to the left
side if you choose.
•
The shelf mounting arm has three positions.
Choose the height that best suits your
installation.
•
Do not confuse the video conferencing shelf
with the laptop shelf. The laptop shelf is an
optional item and is smaller than the video
conferencing shelf.
4
Advertisement
Table of Contents
