Table of Contents
Advertisement
Connect to the gas supply
The inlet to the cooker is
internal situated at the rear right corner.
Fit the bayonet connection. This should
be located so as to ensure the flexible
connector hose does not kink.
Use a 900mm - 1125mm length of
flexible connector.
Ensure that all pipe work is of the correct
rating for both size and temperature.
Natural Gas - Flexible connections
should comply with BS 669. Parts of
the appliance likely to come into
contact with a flexible connector have
a temperature rise of less than 70˚C.
After installation, make sure all
connections are gas sound.
Installation Instructions
" BSP
⁄
1
2
22
Commissioning
Burner aeration
All burners have fixed aeration and no
adjustment is possible.
Pressure setting
G20 Natural Gas @ 20 mbar
Pressure test point
Use the oven injector
Grill - Turn the control knob to the
position, wait a second before
ON
pressing the ignition switch or holding
a lighted match or taper to the burner.
Allow the grill to run for a few minutes
to ensure that the cooling fan operates.
Hob - Turn the control knob to the
position, wait a second before
ON
pressing the ignition switch or holding
a lighted match or taper to the burner.
Oven - Open the oven door. Push in
and turn the control knob to the full on
position (gas mark 9). Hold the control
knob in and operate the ignition
button. A few seconds after the flame
has established, the control knob can
be released.
Before leaving the installation
1. Place all the loose parts of the
cooker into position.
2. Show the customer how to operate
the cooker and give them this
handbook. Thank you.
FULL
FULL
Hide quick links:
Advertisement
Table of Contents
