Initial Set-Up - Sharp MX-M904 Technical Handy Manual

Initial Setup
UNPACKING & LOCK REMOVAL
Use Skid Slopes
Operation Panel installation.
Remove Tray Lift Lock Plates.
Release Fusing Pressure.
DEVELOPER SET-UP
Sim 25-02
Toner Installation must be performed after Auto Developer Adjustment is
completed.
**For optimum image quality & performance, it is recommended to setup &
install developer at the customer site.
TONER INSTALLATION & REPLENISHMENT
Install K Toner Cartridge.
PRODUCT ACTIVATION & FIRMWARE UPGRADE
Activation of Optional Product(s):-
Sim 22-05
INITIAL SETUP
Sim 21-01
Sim 26-02
Sim 26-06
Sim 26-35
Sim 26-52
Sim 40-12
Sim 55-03
System Settings: Adjust Date/Time (Inc. Daylight Saving setting).
Set cassette size by adjusting the guides in the cassette.
Paper Size & Type
PRINT ENGINE IMAGE SKEW
Sim 64-02
10
[UKOG-0367FCZZ]
Auto Developer Adjustment - Select K.
Check Firmware version(s):-
Maintenance Cycle Setting:-
LCC Installation (Paper Size).
Machine Destination.
Set Multi Error Counter:-
Non Printed Paper Counter Set-up.
Multi Purpose Tray (Tray 4) Adjustment/Calibration.
Process Mixed Original Printing for Duplex:-
SSW 3-6, 0 = Disable, 1 = Enable.
Setting:- System Settings – Paper Tray Settings.
Image Writing Adjustment:-
Select A=5, B=1, C=254, D=255, E=1, F=1, G=8.
to remove device from shipping pallet.
System Settings – Product Key.
Upgrade to latest version.
Set PM Counter = 500k,
Set to 1 (Multi Count).
SHARP
Document Solution Centre