Sharp MX-M904 Technical Handy Manual page 42

SD Card Replacement Procedure
Only limited data that is stored on the CF Card can be backed up and reinstalled following replacement or
CF card failure. If the CF Card is operating normally before replacement, backup the data and then
reinstall the data onto the replacement CF Card.
Partition
Number
ICU firmware
L-101
data
ICU firmware
S-101 fixed data (Pre-
install)
S-102 System Data
Replacement Procedure:
When replacing the CF card, be sure to use the specified CF card supplied as a service part only.
The firmware required for booting the MFP device must be included on the CF card that is used in
this machine - Commercially available CF cards do not have this firmware data.
1. Use SIM56-02 to backup the CF card data to the USB memory.
2. When the operation panel home screen has been customised, backup the CF card data by using
the device cloning function.
3. Replace the CF card with a new one.
4. Upgrade the firmware to the latest version.
5. Use SIM56-02 to restore the data backed up in procedure 1.
6. Restore the data backed up in procedure 2 by using the device cloning function.
Note:
If E7-A6 trouble occurs and the error cannot be cancelled, this may indicate an issue or failure of
•
the CF Card – replace the CF Card by following the procedure detailed above.
42
Stored Data
ICU firmware (Including OS section)
Font
Web help
SPDL
Option Font ROM
UI Action Script main program
UI screen information (XML)
Flash image
Flash language data
Flash guidance animation
Setting value data file (System setting/SIM
setting data (Image quality
adjustment)/FAX Soft SW)
Backup
Method
-
-
-
-
-
-
-
-
-
-
SIM56-02
Document Solution Centre
SHARP
Data
Reinstall
Method
SIM49-01
(BOOT
cannot be
installed
again.)
SIM49-01
SIM49-01
SIM49-01
SIM49-01
SIM49-01
SIM49-01
SIM49-01
SIM49-01
SIM49-01
SIM56-02