Sharp MX-M904 Technical Handy Manual page 40

MX-EB15 Mirroring Kit
4. Check that E7-03 trouble does not occur, and the UI icon which indicates rebuilding of the
mirroring kit is displayed.
5. Execute SIM62-20 to confirm that the HDD status is displayed as HDD1/HDD2=OK/OK.
6. Power OFF the MFP device (Primary power switch) and set DIPSW1 to OFF.
7. Power ON the MFP Device
8. Clear the FAX/SCANNER image memory by executing SIM66-10:-
This memory must be cleared for all models equipped with FAX/I-FAX and Network Scanner in order to
keep compliance between the HDD data and the image related memory.
9. Install the E-Manual Data onto the HDD using SIM49-03.
10. Install Watermark data onto the HDD using SIM49-05:-
U2-60 trouble will be displayed when no Watermark data is present . After installing the
Watermark data, reboot the MFP and cancel U2-60 trouble by executing SIM16.
11. Import the storage data backed up in Step 1.
• Use SIM56-02 or device cloning/storage backup function to import the Address book, Image
Send registration data and User authentication data etc.
• Import the Document Filing data, User font and macro data - (The JOB LOG data can be backed
up but cannot be imported).
Caution:
When replacing the HDD for the mirroring kit, ensure to use a new HDD unit.
•
If an HDD that has been previously used for a mirroring kit is used to replace a HDD, the
•
operations and the data cannot be assured.
If an HDD that has been previously used for a mirroring kit is installed, the original data may be
•
erased.
When removing the HDD after installing the mirroring kit, be sure to remove both HDD's
•
together.
If only one HDD is removed and then reinstalled, the data of both HDD's may
•
not be identical, causing an error.
When removing the HDD for maintenance reasons only, disconnect the HDD SATA connector of
•
the MFP PWB first, and then perform the required maintenance. With this procedure, both
HDD's are disconnected from the machine.
40
Document Solution Centre
SHARP