Sharp MX-M904 Technical Handy Manual page 70

Repair Hints
DOCUMENT FILING / PUBLIC FOLDER
Unable to browse the NAS/Public
Folder, even though the Public
Folder/NAS settings are enabled within
ALL
the Network Settings menu.
Can you use Domain User Accounts to
browse the NAS/Public Folders?
TROUBLE CODES
ALL E7-48 after MX-EB11 installation
MX-LC13 U6-54 after installing two MX-LC13s
GENERAL / MISC
Unable to perform Pamphlet Copy with
Saddle Stitch or C-Fold, Accordion Fold,
ALL Half Fold or Double Fold output using
Copy mode only, even though the
required output options are installed
"Check The Connection Between The
Main Unit And The Paper Pass Unit"
MX-LC13 (Copy Mode) or "Paper Empty" (Print
Mode) messages when selecting paper
What is the function of the Digital Line
Network checkbox?
MX-FX11
When using the LCD panel to change
System Settings, only Top Page and
System Settings are listed within the
70
feed from the LCT.
menu.
The NBT/WINS Port (Security setting) must be enabled to
use NAS/Public storage. For security measures, this port
setting is disabled as default.
NAS/Public Folders support local accounts only
(programmed on MFP)
To support the MX-M904/1054/1204 series, upgrade the
MX-EB11 (ACRE) firmware to 04.00.A1 (or higher)
To support the installation of two MX-LC13, upgrade the
MX-LC13 firmware to v01.05.S1 (or higher)
Ensure the Original Feeding Mode for Copy is NOT set for
Mixed Size Documents.
Check Settings – Device Control or Others menu.
Ensure the screw that is used to lock the MX-LC13 to the
main body is loose. If this screw is left tight, the locking
mechanism will not work and the locking sensor will not
be actuated.
In past examples, when connecting the FAX machine to an
IP telephone network, if the outgoing signal level was
high, communication trouble frequently occurred.
Because of the above, there were many cases where
technicians had to adjust the outgoing signal level via FAX
Soft SW when this occurred.
For this reason, the above setting has been added to
avoid communication trouble when connected to an IP
telephone network. This setting can be changed within
the MFP web page by the administrator.
System Settings –> Image Send Settings –> Fax Settings –>
Default Settings.
When Digital Line Network is enabled (ticked), the signal
outgoing level of FAX is set to -15dBm
Go to the service webpage
http://IP_Address_of_MFP/service_login.html.
Default Username & Password= "service".
Select "Administration Settings" and execute "All" to
display all the settings.
SHARP
Document Solution Centre