XAC XPED-8006L2-3CR Installation Manual page 2

1. POWER ON THE 8006 PIN PAD
There are three model of communication interface for xPED-­‐8006L2-­‐3CR: USB interface cable,
RS232 i nterface c able, P OE i nterface c able.
POE i nterface c able: T here i s a f ixed P OE i nterface c able a t t he t op e nd o f 8 006 d evice a s
§
Figure 1 f or p ower a nd c ommunication c onnection t o t he t erminal o r P C. P OE i nterface
cable c an s upply t he p ower b y t wo o ptions b elow
a. From R J45 p ort
If Ethernet cable is able to supply the power, plug on the RJ45 cable into RJ45 port (Figure 2) can
power o n t he d evice.
b. From M icro U SB p ort
Micro USB cable can also supply power to the device by plugging on the micro USB cable into micro
USB p ort ( Figure 3 ).
Note: Turn o ff o r u nplug t he t erminal/PC w henever y ou c onnect o r d isconnect t he P IN P ad. Be s ure t he
terminal/PC i s n ot p rocessing d ata w hen p owering d own.
2 i n 1 U SB 2 .0 p lug w ith M icro U SB j ack
§
USB 2.0 plug is mainly used to connect the device to PC for ActiveSync (Figure 4) while micro USB jack is
for p ower s upply ( Figure 6 ).
2 i n 1 R S232 ( DB-­‐9) p lug w ith M icro U SB j ack
§
It i s m ainly u sed t o c onnect t he d evice t o P C f or s erial p ort c ommunication ( Figure 5 ) w hile m icro U SB j ack
is f or p ower s upply ( Figure 6 ).
Figure 4 Figure 5 Figure 6
Input r ating: D C 5 V, 1 .0A a nd/or D C 4 8V, 2 70mA ( supplied b y E thernet I nterface A dapter)
§
AC a dapter:Hon-­‐Kwang,type:HK-­‐UA-­‐050A100-­‐XX ( XX = A U,EU,GB,US)
§
Operating T emperature: 0 ºC ~ 4 0 º C
§
Figure 2 Figure 3
Figure 1