Table of Contents
Advertisement
NAME AND FUNCTIONS OF REMOTE CON-
TROLLER
• The illustrations in this operating manual correspond to the remote controller format BRC1C type.
Operation Mode Display
Indicates the current mode of
operation as shown below:
Fan operation
Cooling operation
Heating operation
Inspection/
Test Operation Display
Press the Inspection/Test
Operation button (during
maintenance), then one of
the two displays will appear.
• Do not use this function at
ordinary times.
Programmed Time Display
Indicates the time set by the
timer.
Set Temperature Display
Indicates the set temperature.
English
Defrosting/Hot Start Display
See page 9.
Operation Lamp (Red)
This lamp remains lit while the
unit is running.
CAUTION
• Do not drag or twist the wire connecting the remote
controller, otherwise a fault may result.
• Do not touch any button of the remote controller with a
sharp object; doing so may damage the remote controller
or cause a fault.
NOTE
• The above illustration is intended for the explanation of the
display and therefore differs from the actual display during
operation.
DISPLAY
ON/OFF Button
Press the button once to start
the unit.
Press it again to stop the unit.
Under Centralized
Indicates the unit is
under centralized
control.
Non-Function Display
• When the operation button
is pressed, sometimes
"NOT AVAILABLE" will be
displayed continuously for
several seconds if a certain
function is not available
with the indoor unit.
• When several units are
running simultaneously,
"NOT AVAILABLE" will be
displayed only when a
certain function is not
available with all indoor
units. As long as one unit
has this function, "NOT
AVAILABLE" will not be
displayed.
Control Display
1
Advertisement
Table of Contents
