The Security Menu - General Dynamics Itronix GoBook VR-2 Help Manual

VR-2 Help
IDE Controller
HDC Configure as
SATA Port 0 Hotplug
SATA Port 1 Hotplug
SATA Port 1 ILS
SATA Port 2 Hotplug
Primary IDE Cable Type
Channel 1 Master
Channel 1 Slave
Channel 2 Master
Channel 2 Slave
Channel 3 Master
Channel 3 Slave
Channel 4 Master
Channel 4 Slave

The Security Menu

You can set, change or remove passwords in the Security menu.
file://C:\Documents and Settings\harwoodm\Local Settings\Temp\~hh3F7F.htm
Enabled If enabled, both the PATA and
Disabled SATA IDE Controllers are enabled.
If disabled, both the PATA and
SATA IDE controllers are disabled.
PATA Only Sets the Harddisk Controller
Configuration Type.
SATA Only
IDE
Combined
IDE Non-
Combined
AHCI
If enabled, the SATA Port 0
Enabled
Disabled Hotplug is enabled.
If enabled, the SATA Port 1
Enabled
Disabled Hotplug is enabled.
Enabled If enabled, the SATA Port 1
Disabled InterLock Switch is enabled.
Enabled If enabled, the SATA Port 2
Disabled Hotplug is enabled.
Auto Determines the type of IDE Cable
used.
40 Pins
80 Pins
Not If a drive is installed, its
Installed manufacturer, drive type, and model
are displayed. Pressing [Enter]
(Drive
displays additional drive and setting
Model)
information:
Not
Installed
Type :
Not
Installed
If USER Defined is enabled, the
following settings can be changed:
(Drive
Model)
32Bit I/O
Not
Installed
Block Mode:
Not
<Enabled/Disabled>
Installed
Transfer Mode:
Not
<Enabled/Disabled>
Installed
Security Mode:
<Auto/User Defined>
<Enabled/Disabled>
Page 50 of 70
4/26/2007