Ingenico Link/2500 User Manual page 4

Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This transmitter must not be co‐located or operating in conjunction with any other
antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
SAR tests are conducted using standard operating positions accepted by FCC the with the
device transmitting at its highest certified power level in all tested frequency bands.
For hand-held operation, this device has been tested and meets the FCC RF exposure
Guidelines when used with an accessory designated for this product or when used with an
accessory that contains no metal. N on‐compliance with the above restrictions may result
in violation of RF exposure guidelines.
For mobile exposure condition use, for satisfying RF exposure compliance, the device must be
installed to provide a separate distance of at least 20 cm from all persons.
USER GUIDE •
R11 900019007 000 02
4/22 Copyright © 2012 Ingenico
All rights reserved