Supermicro SuperServer series User Manual page 28

SuperServer E200-9AP User's Manual
TPM Header
The JTPM1 header is used to connect a Trusted Platform Module (TPM), which is available from
a third-party vendor. A TPM is a security device that supports encryption and authentication in
hard drives. It enables the motherboard to deny access if the TPM associated with the hard
drive is not installed in the system. See the table below for pin definitions.
Trusted Platform Module Header
Pin Definitions
Pin# Definition
1 LCLK
3 LFRAME#
5 LRESET#
7 LAD3
9 3.3V
11 LAD0
13 SMB_CLK4 (X)
15 P3V3_STBY
17 GND
19 P3V3_STBY
GPIO Headers
The JGP1 (General Purpose Input/Output) header is located near the SATA connectors on
the motherboard. The JGP1 header is a general-purpose I/O expander on a pin header from
Intel SoC.
GPIO Memory Address Table
Pin# SoC GPIO #
1 Power
2 Ground
3 GP0
4 GP4
5 GP1
6 GP5
7 GP2
8 GP6
9 GP3
10 GP7
Note: The "I2C#_SCL/SDA" are pin names of Intel N3700 SoC GPIO.
Pin# Definition
2 GND
4 No Pin
6 +5V (X)
8 LAD2
10 LAD1
12 GND
14 SMB_DAT4 (X)
16 SERIRQ
18 GND
20 LDRQ# (X)
Pin Definitions
Memory Address
0xD0C70578
0xD0C70558
0xD0C70570
0xD0C70550
0xD0C70568
0xD0C70548
0xD0C70560
0xD0C70540
28
19 1
20 2
JTPM1 Pin Layout
2 10
9
1
GPIO Header Pin Layout