Table of Contents
Advertisement
Updating the MWS1000
This appendix describes how to upload a new firmware version into the MWS1000 device.
To upload a new firmware version into the MWS1000 device
1. Connect a Category 5 (CAT5) Ethernet cable from the Ethernet port of the MWS1000 to
your computer.
2. Power up the MWS1000 device.
3. Configure your computer to be on the same subnet as the MWS1000 (refer to Changing
Your Computer's IP Address on page 21). Since this disconnects your computer from
your computer network, you may need to restore this setting later.
4. Open a WEB browser and enter the MWS1000 Client's address: 10.0.0.10
5. The following user/password screen appears:
Enter admin as the user space and admin as the password and press OK.
Design. Build. Ship. Service
A
Advertisement
Table of Contents
