Pairing Your Devices - Flextronics MWB1300 User Manual

Pairing your Devices

Note: Consult with the quick installation guide that came with your kit to check if the
devices in your kit are already paired, in which case you can skip this step. .
1. Place the MWB1305 Access Point and the MWS1000 Client devices between 1 to 3
meters from each other.
2. Pair the devices by pressing the WPS button on the MWB1305 and MWS1000 rear panel
for 5 seconds. You can release the button as soon as the WLAN LED begins flashing.
Note: The WPS buttons should be pressed within 2 minutes period. The buttons can be
pressed in any order.
3. Wait for the pairing process to complete by watching the LEDs on the devices:
While pairing is in progress the WLAN LED is flashing green
After successful pairing the Link Quality LED is flashing green for 30 seconds.
Pairing is in progress
Copyright © 2009 Flextronics Special Business Solutions | Design. Build. Ship. Service
Figure 7 - Pairing the devices
Pairing has finished successfully
pg. 17