HP Netserver LP2000r Service Manual page 41

Chapter 4
Code Description
0301 Flexible disk drive (B)
boot error
(This does not apply
to LP 2000r)
0305 Flexible Disk Drive
Cable conflict
(This does not apply
to LP 2000r)
0306 Flexible disk drive
controller boot error
0307 Flexible disk drive
controller resource
conflict
0400 CD-ROM boot error
Problem/Solution
POST has detected the flexible disk drive (B) reported an error
during its self-test.
1. Verify a diskette can be properly inserted and removed from
the flexible disk drive.
2. Verify the flexible drive type configured in the Setup Utility
matches the flexible disk drive installed in the HP Netserver.
3. Verify all data cables and power cords are firmly connected.
4. If the problem persists, your flexible disk drive may need to
be replaced. Contact your service representative.
The flexible disk drive (A) is connected to the connector configured
for flexible disk drive (B).
1. Run Setup Utility by pressing [F2]. In the flexible disk drive
section, enable the A & B flexible disk swap.
2. Alternatively, if the connector allows it, connect the flexible
disk drive to the other connector on the flexible disk drive
cable.
POST has detected a general failure on the integrated flexible disk
controller.
To verify this:
1. Restart your HP Netserver.
2. If the error persists, your system board may need to be
replaced. Contact your service representative to replace your
Netserver.
POST has detected an address space or IRQ resources conflict
between the integrated flexible disk controller and an accessory
board.
To correct this:
1. If the integrated flexible disk controller is not needed, run the
Setup Utility and disable the flexible disk controller.
2. If the integrated flexible disk controller is needed, the
accessory board's IRQ and address space must be
reconfigured to use other free resources. Refer to the
accessory board installation manual for information.
POST has detected the CD-ROM drive has reported an error during
its self-test.
To correct this:
1. If a CD-ROM disk is present, verify it is correctly inserted.
2. Verify the CD-ROM drive door or tray has not been opened
or closed during the self-test.
3. Verify all data cables and power cords are firmly connected.
4. If the problem persists, your CD-ROM drive may need to be
replaced. Contact your service representative to replace your
Netserver.
Diagnostics
35