HP Netserver LP2000r Service Manual page 39

Chapter 4
Code Description
0076 Integrated HP
NetRAID processor is
not responding.
(This does not apply
to LP 2000r)
0100 Keyboard error during
POST
0101 Keyboard error
(The LP 2000r will
complete the boot
process without a
keyboard connected.)
0102 Keyboard controller
error during POST
0103 Keyboard is not
connected.
(The LP 2000r will
complete the boot
process without a
keyboard connected.)
0105 Mouse boot error
(The LP 2000r will
complete the boot
process without a
mouse connected.)
Problem/Solution
This problem will prevent the operation of the Integrated HP
NetRAID, if it is enabled. The problem may also prevent operation of
some PCI slots.
1. Flash the Integrated HP NetRAID firmware and reboot the
system.
2. If the error persists, your I/O board may need to be replaced.
Contact your service representative.
A key on the keyboard has been pressed during POST of the HP
Netserver.
To correct this:
1. Ensure nothing is put on the keyboard and no key is
accidentally pressed down.
2. Reboot the Netserver.
3. If the error persists, your keyboard may need to be replaced.
Contact your service representative.
The keyboard has reported an error during its self-test.
To correct this:
1. Restart your HP Netserver.
2. If the error persists, your keyboard may need to be replaced.
Contact your service representative.
POST has detected a general failure in the integrated keyboard
controller.
To verify this error:
1. Restart your HP Netserver.
2. If the error persists, your system board may need to be
replaced. Contact your service representative to replace your
Netserver.
POST has detected the keyboard is not connected.
To correct this:
1. Verify the keyboard connector is firmly connected.
2. Reboot the Netserver.
3. If the problem persists, your keyboard cable may be
damaged or your keyboard may need to be replaced. Contact
your service representative.
The system board has detected a mouse error during POST.
To correct this:
1. Clean the mouse and its moving ball as described in the
User's Guide.
2. If the problem persists, your mouse may need to be replaced.
Contact your service representative.
Diagnostics
33