Problems Running The Setup Utility - HP Netserver LP2000r Service Manual

Chapter 4
8. Insert the new battery with the positive sign (+) facing up in the socket.
9. Press down on the center of the battery with your thumb, pushing the battery down into the
socket.
The battery should snap into place.
10. Ensure the spring latch holds the battery firmly.
11. Replace the cooling duct/cover and the Netserver cover.
12. Power on the Netserver and reset the CMOS settings.

Problems Running the Setup Utility

If you cannot run the Setup Utility, the HP Netserver's configuration in CMOS memory may have become
corrupt. The only way to recover from a corrupted configuration is to clear it. Refer to "Clearing the CMOS
Configuration," earlier in this chapter.
Battery on System Board
Diagnostics
45