Cblh Front Panel Without Bezel - Hitachi F800 Hardware Reference Manual

5
6
Note: Removing a controller can cause the POWER, READY, WARNING, and
ALARM LEDs on the front panel to turn off. These LEDs return to the on status
after the storage system recovers from the controller replacement.

CBLH front panel without bezel

The following table describes the definitions of the CBLH controller front panel
LEDs.
1
2
3
Hitachi Virtual Storage Platform F800 Hardware Reference Guide
Number
POWER ON/OFF (main switch)
Lock
Number
POWER ON/OFF (main switch)
POWER, READY, WARNING, and
ALARM LEDs
Controllers
Virtual Storage Platform F800 controller
Item
Red: Processor failure (system
might be down). Go to the
Customer Contact Us page at
https://support.hds.com/
en_us/contact-us.html.
Powers the storage system.
Locks and unlocks the front
panel bezel by using the
supplied key.
Item
Powers the storage system.
Note: When System Option
Mode 1097 is set to ON, the
WARNING LED does not blink,
even if the following failure
service information messages
(SIM) are issued: 452xxx,
462xxx, 3077xx, 4100xx, and
410100.
Controller 1 (bottom) and
Controller 2 (top).
Description
Description
21