ABB RET650 Applications Manual page 252

Section 12
Logic
12.1.2.1
12.1.2.2
246
To prevent closing of a circuit breaker after a trip, the function offers a lockout
function.
Three-phase tripping
Connect the inputs from the protection functions to the input TRIN. The TMGAPC
function block is used to combine up to 32 inputs into one output. Connect the
output TRIP to the binary outputs on the IO board.
This signal can also be used for other purposes internally in the IED. An example
could be the starting of breaker failure protection. The three outputs TRL1, TRL2,
TRL3 will always be activated at every trip and can be utilized on individual trip
outputs if single-phase operating devices are available on the circuit breaker even
when a three-phase tripping scheme is selected.
Set the function block to Program = 3 phase and set the required length of the trip
pulse to for example, tTripMin = 150ms.
The typical connection is shown below in figure 90.
Protection functions with 3 phase
trip, for example time delayed
overcurrent protection
IEC05000544 V4 EN-US
Figure 90: Tripping logic SMPPTRC is used for a simple three-phase tripping
application
Single- and/or three-phase tripping
The single-/three-phase tripping operation mode will give single-phase tripping for
single-phase faults and three-phase tripping for multi-phase fault. This operating
mode is always used together with a single-phase autoreclosing scheme.
The single-phase tripping operation mode can include different options and the use
of the different inputs in the function block. Inputs TRINL1, TRINL2 and TRINL3
SMPPTRC
BLOCK
TMAGAPC
BLKLKOUT
TRIN
TRINL1
TRINL2
TRINL3
PSL1
PSL2
PSL3
1PTRZ
1PTREF
P3PTR
SETLKOUT
RSTLKOUT
STDIR
Transformer protection RET650 2.2 IEC
1MRK 504 169-UEN A
M14828-7 v10
TRIP
TRL1
TRL2
TRL3
TR1P
TR2P
TR3P
CLLKOUT
START
STL1
STL2
STL3
STN
FW
REV
IEC05000544-4-en.vsdx
M14828-11 v6
Application manual