Maytag MGR5870 User Manual page 24

Maintenance
(continued)..................................
Leveling Legs Proportional Valve Adjustment
IAL for Surface Burners
CAUTION:
[ • Be sure anti-tip bracket secures one of the rear leveling TheLOWsettingshouldpro-
] legs to the floor. This bracket prevents the range from duce a stable flame when
accidentally tipping, turning the knob fromHIGH
to LOW. The flame should
The range should be leveled when installed. If the be 1/8inch or lower and must
range is not level, turn the plastic leveling legs, be stable on all ports on LOW
located at each corner of the range, until setting.
range is level. To adjust: Operate burner
on HIGH for about five minutes to preheat burner c
ANr_-r_ 8RACKErTurn knob back to LOW; remove knob, and insert asn
screwdriver into the center of the valve stem. Adjust
LeVZLJNGLZG flame size by turning adjustment screw in either di
tion, while holding the stem.
Electrical Connection
Flame must be of sufficient size to be stable on all bu_
Appliances which require electrical power are _ ports. If flame adjustment is needed, adjust ONLY o_
equipped with a three-prong grounding plug I _ LOW setting. Never adjust flame size on a higher sett
whichmustbepluggeddirectlyintoaprop- _ "._'j NOTE: All gas adjustments should be done It
erly grounded three-hole 120 volt electri- _-----,_ o qualified servicer only.
cal outlet. S_'/I (_
Always disconnect power to appliance I J
How to Remove Range
before servicing,
for Cleaning and Servicing
The three-prong grounding plug offers protection against shock
Follow these procedures to remove appliance for cl
hazards. DO NOT CUT OR REMOVE THE THIRD
GROUNDING PRONG FROM THE POWER CORD ing or servicing:
PLUG. 1. Shut off gas supply to appliance.
If an ungrounded, two-hole or other type electrical outlet is 2. Disconnect electrical supply to appliance, ifequil:
encountered, it is the personal responsibility of the appli- 3. Disconnect gas supply tubing to appliance.
anee owner to have the outlet replaced with a properly
grounded three-hole electrical outlet. 4. Sliderange forward to disengage range from the
tip bracket. (See Installation Instructions for loc
of bracket.)
5. Reverse procedure to reinstall. If gas line has
disconnected, check for gas leaks after reconne,
NOTE: A qualified servicer should disconne(
reconnect the gas supply.
6. To prevent range from accidentally tipping,
must be secured to the floorby sliding rear leveli
into the anti-tip bracket.
23