Electrical Safety Advisory; Declaration Of Conformance; 47 Cfr Part 68 Information - Arris BGW210-700 Install And Operation Instructions

Do not use the telephone to report a gas leak in the vicinity of the leak.


Electrical Safety Advisory

Telephone companies report that electrical surges, typically lightning transients, are very
destructive to customer terminal equipment connected to AC power sources. This has been
identified as a major nationwide problem. Therefore it is advised that this equipment be
connected to AC power through the use of a surge arrestor or similar protection device.

Declaration of Conformance

Warning: This is a Class B product. In a domestic environment this product may cause radio
interference, in which case the user may be required to take adequate measures. Adequate
measures include increasing the physical distance between this product and other electrical
devices. Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
United States: This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.
Consult the dealer or an experienced radio/TV technician for help.


47 CFR Part 68 Information

United States: This device complies with 47 CFR Part 68 of the FCC Rules. Operation is subject
to the following four conditions:
365-095-30882 Revision 4.0
© 2016 ARRIS Enterprises LLC. All Rights Reserved.
BGW210-700 Broadband Gateway Release 1.0 Install and Operations Guide
Chapter 6: Important Safety Instructions
28