Display, Operating Times; Line 7; Setting The Clock; Checking Stored Alarms - IVT Greenline D14 Manual To Installation, Commissioning And Maintenance

Line 7

Main menu
Op. time readings on
HP and add. heat
Return Select
Op. time readings
Heat pump in operat.
number of hours? 7.1
Return Select
Op. time readings
Distribution HP
DHW-Rad in %
Return Select
Op. time readings
Add. heat in operat.
number of hours? 7.3
Return Select
Op. time readings
Distribut. add. heat
DHW-Rad in %
Return Select
Line 10
Main menu
Clock, setting
time and date
Return Select
Line 11
Main menu
Alarm logging
of all alarms
Return Select
Line 12
Main menu
Return to
factory settings
Return Select
In line 7 you can read the running times for the heat pump
7 and additional heat. Press "Select" to enter these menus.
Here you can see how many hours the heat pump has been
in operation.
This shows the distribution of the heat pump between hot
Not
water and heating as percentages.
operating
mode C
7.2
Here you can see how many hours the additional heat has
been in operation.
Not
operating
This shows the distribution of the additional heat between
7.4
mode C
hot water and heating as percentages.
You can set the heat pump's clock to the correct time if it is
wrong on line 10.
10
Line 11 shows a record of the alarms that may have oc-
curred on your heat pump. You can see the type of alarm
and when it occurred. An * in the display means the alarm is
11
still active.
If you want to change your settings at customer levels 1 and
2 you can return to factory settings on line 12.
12
Please note: If you are on the installer/service level when
you choose factory settings, the installer must carry out a
new start-up of the plant with the new settings. The installer/
service level is for installer only. As an end-user you should
never go into this level!
17