Table of Contents
Advertisement
Control unit Rego600
If you are an installer, note that you can find certain information about the operation of the control unit
in the sections that are intended for the end user. It is therefore important for installers to read the
guide before putting the heat pump into service.
Installer/service settings
As installer Installer / Service gives you access to all the menu displays that the end user has at cus-
tomer levels 1 and 2. Note that the menu display is connected to the selected operating mode. You will
never see displays that concern anything else but the selected operating mode.
Installer/service menu
By keeping down Menu for 10 seconds and then enter Menu you
will come to settings for installers or service companies. The
Menu display is divided into lines and each display has a number
to make it easy to find. You will automatically return to level 1
again after 30 seconds.
Joint displays for operating modes A, B and C
Line 1
Temperature settings
Heat curve
adjust. (break)
Return
Line 4
Clock setting
Clock sett. add heat
accord. to clock 4.2
Return
Select
Line 5
Commiss./Service
Manual operation of
all functions
Return
1.3
Select
5.3
Select
Here you can "break" the heat curve up or down for each
fifth degree outdoor temperature. You can e.g. do a tempo-
rary increase on the curve at 0°C outdoor temperature.
You can block the additional heat totally during certain times
of day. Instructions are found under the chapter on clock
controls at increased customer level.
When controlling functions you can here manually start and
stop pumps and valves etc.
53
Rego600
020312
12.00.00
Heat
Info
WARNING!
Installer only. As end-user you must
never go into this level!
I/S
Ti
Menu
- Quick Links:
- C Series Components
Hide quick links:
Advertisement
Table of Contents
