Line 7; Alarm Logging Of All Alarms - IVT GreenlineC Manual To Installation, Commissioning And Maintenance

Line 7

Main menu
Op. time readings on
HP and add. heat
Return Select
Op. time readings
Heat pump in operat.
number of hours? 7.1
Return Select
Op. time readings
Distribution HP
DHW-Rad in %
Return Select
Op. time readings
Add. heat in operat.
number of hours? 7.3
Return Select
Op. time readings
Distribut. add. heat
DHW-Rad in %
Return Select
Line 10
Main menu
Clock, setting
time and date
Return Select
Line 11
Main menu
Alarm logging
of all alarms
Return Select
Line 12
Main menu
Return to
factory settings
Return Select
In line 7 you can read the running times for the heat pump
and additional heat. Press "Select" to enter these menus.
7
Here you can see how many hours the heat pump has been in
operation.
This shows the distribution of the heat pump between hot
Not
water and heating in percentage.
operating
7.2
mode C
Here you can see how many hours the additional heat has
been in operation.
Not
This shows the distribution of the additional heat between
operating
7.4
hot water and heating in percentage.
mode C
You can set the clock to the correct time if it is wrong.
10
Line 11 shows a record of the alarms that may have occurred
on your heat pump. You can see the type of alarm and when
it occurred. An * in the display means the alarm is still
11
active.
If you want to change your settings at customer levels 1 and
12
2 you can return to factory settings on line 12.
Please note: If you at the level for installer/service when you
choose factory settings, the installer must carry out a new
start-up of the plant with new settings. The installer/service
level is for installer only. As end-user you must never go into
this level!
17