Elba S 66 X 938 Instructions For Use Manual page 24

INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a mild
detergent solution and warm water. Suita-
ble proprietary chemical cleaners may be
used after first consulting with the manu-
facturers recommendations and testing a
small sample of the oven cavity. Abrasive
cleaning agents or scouring pads/cloths
should not be used on the cavity surface.
NOTE: The manufacturers of this applian-
ce will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
ASSEMBLY AND DISMANTLING OF
THE SIDE RUNNER FRAMES
• Fit the side runner frames "G" (interpo-
sing the catalytic panels "A") into the
holes on the side walls inside the oven
(Fig. 6.1).
• Slide in, on the guides, the shelf and
the tray etc. fig. 6.2.

The rack must be fitted so that the sa-
fety catch, which stops it sliding out,
faces the inside of the oven (fig. 6.2).
• To dismantle, operate in reverse or-
der.
ADVICE FOR USE AND MAINTENANCE
OF SELF CLEANING PANELS
The self cleaning panels are covered with
a special microporous enamel which, ab-
sorbs and removes oil and fat splashes du-
ring normal baking over 200°C.
If, after cooking very fatty foods, the panels
remain dirty, operate the oven empty on
max temperature for about 30 minutes.
These panels do not require to be cleaned,
however it is advised to periodically remo-
ve them from the oven (at least the side
panels) and to wash them with tepid soapy
water and then wipe off with a soft cloth.
24
Fig. 6.1
Fig. 6.2
DO NOT CLEAN OR WASH THEM WITH
ABRASIVE PRODUCTS OR WITH PRO-
DUCTS CONTAINING ACIDS OR ALKALIS.
The side panels are reversible and when
the microporous enamel degrades, they
can be turned to the other side.
A G