Solid-State Drive (Ssd) - HP 15-cb000 Maintenance And Service Manual

Solid-state drive (SSD)

Description
256 GB, PCIe
128 GB, PCIe
128 GB, SATA-3
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to reassemble and install the solid-state drive.
Bottom cover on page
Battery on page
Solid-state drives are designed with notches to prevent incorrect insertion.
35).
37).
Component replacement procedures
Spare part number
847109-020
912322-007
827560-052
43