Table of Contents
Advertisement
NETWORK CONFIGURATION
Network Setup for Internal Access
The VMAX HD can be setup to be accessed remotely either from within the network
or externally via the internet.
1. Right-click on the screen and select Menu. Go to Network
2. Select the network type.
[DHCP] If selected, the system will automatically assign the DVR an IP address, subnet mask,
gateway and DNS server that match the network's requirements.
[STATIC] If selected, enter manually all the necessary information below..
N
Contact your Network Administrator & Internet Service Provider for proper network
OTE
configuration.
3. Web Port and Streaming port are set by default to 80 and 5445, respectively. This
information is necessary when connecting to the DVR externally. If necessary, modify
the ports according to your network requirements.
N
Some internet service providers block port 80. It is recommended that you change the
OTE
DVR's web port to 81 or 82 just in case.
4. Network Stream: Use this section to setup the streaming resolution of the DVR's
video over the internet. The higher the resolution and frame rate, the better quality the
image will be. However, the higher the quality, the more bandwidth space it will require.
- Set the resolution for the network stream. Options are "640x360" and "1280x720.
- Set the Frame Rate from 1-30 frames per second.
- Set the Quality of the video from Level 1(low) - Level 5 (High).
N
If the bandwidth is low, the resolution should be set as 640x360.
OTE
Advertisement
Table of Contents
