Metra Electronics 99-5027 Installation Instructions Manual page 11

DIN radio provision with pocket
1. Remove the metal DIN sleeve from the aftermarket
radio.
2. Slide the sleeve into the radio housing and secure
by bending the metal locking tabs down.
3. Slide the radio into the sleeve until it clicks in.
4. Secure the mounting bracket to the back of the
radio housing with the (2) #8 x 3/8" Phillips screws
supplied. (Figure A)
5. Slide the rear support onto the mounting bracket,
and then mount the support to the back of the radio
using the hardware included with the radio. (Figure A)
6. Locate the factory wiring harness and antenna
connector in the dash. Metra recommends using the
proper mating adapter from Metra or AXXESS. Test the
radio for proper operation.
7. Reassemble the dash in reverse order of
disassembly.
99-5027
Kit Assembly
(Figure A)
11