Application Possibility With One-Phase Reb670 - ABB REB670 Applications Manual

1MRK 505 370-UUS A
18.1.2.2
Busbar protection REB670 2.2 ANSI
Application manual
IEC06000519 V2 EN-US
Figure 209: Direct fibre optical connection between two IEDs with LDCM
The LDCM can also be used together with an external optical to galvanic G.703
converter as shown in figure 210. These solutions are aimed for connections to a
multiplexer, which in turn is connected to a telecommunications transmission network
(for example PDH).
Multiplexer
*) Converting optical to galvanic G.703
IEC05000527 V2 EN-US
Figure 210: LDCM with an external optical to galvanic converter and a multiplexer
When an external modem G.703 is used, the connection between LDCM and the
modem is made with a multimode fibre of max. 3 km/2 mile length. The IEEE/ANSI
C37.94 protocol is always used between LDCM and the modem.

Application possibility with one-phase REB670

For busbar protection applications in substations where dynamic zone selection is
required, it is typically necessary to wire the normally open and normally closed
auxiliary contacts from every monitored disconnector and/or circuit breaker to the
Telecom. Network
*)
Section 18
Remote communication
en06000519-2.vsd
Multiplexer
en05000527-2.vsd
*)
M12844-20 v4
493