Kenwood DP-1100 B Service Manual page 91

D P - 1 1 0 0 B II
2. IC OPERATION OF EACH CIRCUIT AND PIN DESCRIPTION
Pin No. Symbol
4 1 , 4 2 NC
43 43 43 43 DA-3 DA-3 DA-3 DA-3
4 4 4 4 4 4 4 4 DA-4 DA-4 DA-4 DA-4
45 45 45 45 DA-5 DA-5 DA-5 DA-5
46 46 46 46 DA-6 DA-6 DA-6 DA-6
47 47 47 47 DA-7 DA-7 DA-7 DA-7
48 48 48 BCK BCK BCK
94
I/O
Waveform
-
-
Not connected.
- - - -
Outputs the fourth bit from LSB
0 0 0 0
of 8-bit data.
Outputs the fifth bit from LSB
- - - -
0 0 0 0
of 8-bit data.
- - - -
0 0 0 0
Outputs the sixth bit from LSB
of 8-bit data.
- - - -
0 0 0 0
Outputs the seventh bit from
LSB of 8-bit data.
/ T T - T V / T T - T V V V
0 0 0 0
Outputs MSB of 8-bit data.
Bit clock pulse is output when serial data is output. Thus, serial data is Bit clock pulse is output when serial data is output. Thus, serial data is Bit clock pulse is output when serial data is output. Thus, serial data is
0 0 0
( )0.2pS output in synchronization with the rising edge of this clock pulse (1.4 output in synchronization with the rising edge of this clock pulse (1.4 output in synchronization with the rising edge of this clock pulse (1.4
\ - _ _ / n \/
MHz). MHz). MHz).
Description
P/S SE = " L "
P/S S E = " H "
Outputs a " H " signal when
correction flag of LSB side is
set side with level of MSB side
at - 3 0 dB.
P/S SE = " L " P/S SE = " H "
1 MCK output.
Outputs
(1.058 MHz)
2-division of signal CK2M.
P/S SE = " L "
P/S S E = " H "
APL output. Outputs R-channel
aperture signal.
P/S SE = " L "
P/S SE = " H "
APL output.
Outputs
signal.
P/S SE = " L " P/S SE = " H "
Outputs music data in serial
from MSB.
T a b l e 2 - 3 - 4 A
Not connected Not connected Not connected Not connected
Not connected Not connected Not connected Not connected
the clock signal
obtained from
Not connected Not connected Not connected Not connected
Not connected Not connected Not connected Not connected
L-channel aperture
Remarks