Kenwood DP-1100 B Service Manual page 153

5 - 3 - 5 R e p l a c e m e n t of tray
R e m o v e the f o u r t a p p i n g s c r e w s of the panel r e i n f o r c e m e n t
plate a n d the f o u r red t a p p i n g
m e c h a n i s m t o the unit as s h o w n in Fig. M 2 8 , restore the tray
t o the state t h a t it is nearly h o u s e d i n , t h e n lift u p the
m e c h a n i s m in its rear side as s h o w n in Fig. M 2 8 - a . T h e metal
fixture (right) of the rail w i l l t h e n be d e t a c h e d s i d e w a y s .
Detach this metal f i x t u r e , t h e n restore the m e c h a n i s m t o t h e
original l o c a t i o n , a n d the tray c a n be pulled o u t f o r w a r d s
m a n u a l l y .
Note: The tray can be detached with a short shaft screwdriver for M2.6
without removing the above eight screws as shown in Fig. M27.
•
D r a w o u t the tray in its o p e n i n g d i r e c t i o n , s l o w l y .
A s s e m b l y s h o u l d be carried o u t in the reverse p r o c e d u r e .
Notes: • When putting in the tray, make sure that gear C is engaged with
the drive rack.
• Be careful not to damage the rollers of main chassis ass'y (28)
by the edges of the rails.
5. MECHANISM OPERATION
s c r e w s s e c u r i n g the
Panel reinforcement plate
Fig. M 2 8 R e m o v a l a n d replacement of tray
Fig. M 2 7 R e m o v a l of tray
Fig. M 2 8 - a